The All New, New "What have you done to your Bay today" thread.

It'll leak air,overheat and explode in a massive ball of molten metal!!!!!!!

 

Like the last one


Sent from my iPhone using Tapatalk

 

Looks amazing!!!


Sent from my iPhone using Tapatalk

 

Gotta tiddy up wiring when it's fitted and new fuel lines !! It's basically same as I have bar the empi linkage !! It's runs and revs really good to


Sent from my iPhone using Tapatalk

 

I'd do it for most of my pals mate less than £800
Long block, new rings ,heads stripped valves lapped ,barrels honed , all new seals , fully powder coated, I rebuilt a used set of 34 webber icts with manifolds and linkage, made new coil bracket, painted all exhaust parts , new fuel lines and filter (all round), new engine mounts , new breather hoses,new leads,new coil,new cap and arm ,new plugs, ballenced carbs and tuned and fully fitted !!! (All this monies is parts have receipts but allso alll new fixings and stainless for free I have around )


Sent from my iPhone using Tapatalk

 

Fitted dash pod seal. Drove van to Screwfix to buy anti-tree-on-your-head hat. Did Jack's Bush and the Wallops again for a run.

 

I had a day off today, so pulled the engine to get at my squeaking fan. As suspected, it had cracked all the way round. It may have been old age, but also could have been over torqued, as I had to use an impact driver to get the nut off. I lashed it down, as I was worried it would fly about the place.


Sent from my Nexus 5 using Tapatalk

 

Have you tried a suppository could ease some of the reverse thrust. Only saying as this has worked in the past.

 

Was it clamped up properly with the bushes/washers in the right order?

 

Tonight I swore alot but managed to transfer a complete built up engine in to the camper ready to install the weekend !!



Sent from my iPhone using Tapatalk

 

How?

 

Great difficulty slid the engine stand under neath and tipped it up whilst mrs yanked out the stand I rested the other end down/dropped


Sent from my iPhone using Tapatalk

 

Are you going the mid-engined route?
If not, your engine is in the wrong place.

 

Twin type 4 engine


Sent from my iPhone using Tapatalk

 

You won't get your scooter in with that there

 

I did this with my engine on a cheap ikea side table! My back hates me!!