Star adjuster thingy

And use a bead of sealant between the plate and bearing carrier when it's refitted


Sent from my iPhone using Tapatalk

 

New cylinder time then


Sent from my iPhone using Tapatalk

 

Yep. Cheap enough though.
Any tips for getting the bearings out?

 

One will fall out...the other won't

 

I can't even shift the inner seal at the moment.

 

Hit em with a hammer

 

Drift from other side small taps all the way around to keep it square @mikedjames took loads of photos where r they mike

 

Slightly bent screw driver levered mine out

 

Who did your first ones....

Shouting... "Anyone left handed" lol

 

I'll try that tomorrow. Given up now. Got to dark. Cheers.

 

Make sure u hit the lip of the bearing if u clean out the grease there is allso a lip that the bearing buts up to u will see it

 

I was in a feild slightly intoxicated and couldn't function so shouted for a lefty

 

Do you have new seals to go in?



Sent from my iPhone using Tapatalk

 

Yeah got whole fitting kit.

 

Then you can put two small screws in the seal and use mole grips on them to tug the seal out


Sent from my iPhone using Tapatalk

 

Good plan.

 

I was gonna do this at te but just incase I had to keep barring never did it the seal should pop out on the thread

 

Claw hammer got my seals out

Sent from my Nexus 6P using Tapatalk

 

Don't forget you've got big f-off circlips to remove...

 

https://www.machinemart.co.uk/p/cla...UWPCXE9zEoVx4awgjR7NGioWqrkmlf49i8aAiDM8P8HAQ easy

Sent from my Nexus 6P using Tapatalk