And use a bead of sealant between the plate and bearing carrier when it's refitted Sent from my iPhone using Tapatalk
Drift from other side small taps all the way around to keep it square @mikedjames took loads of photos where r they mike
Make sure u hit the lip of the bearing if u clean out the grease there is allso a lip that the bearing buts up to u will see it
Then you can put two small screws in the seal and use mole grips on them to tug the seal out Sent from my iPhone using Tapatalk
I was gonna do this at te but just incase I had to keep barring never did it the seal should pop out on the thread
https://www.machinemart.co.uk/p/cla...UWPCXE9zEoVx4awgjR7NGioWqrkmlf49i8aAiDM8P8HAQ easy Sent from my Nexus 6P using Tapatalk