Hi all, I'm in need of help from those in the know....I have attached a schematic picture showing the parts that are missing on my bus( 77 westy ) i've circled them in red. its a spring and a cup of some sort - i think. They help hold the linkage bar in place , sort of keeping it in tension.....i think. They were missing, so I dont have a clue what to get, or from where? Any help would be greatly appreciated. cheers Lee 07903997083
item 4 http://www.vwheritage.com/vw_parts_Inlet-Carburettors-and-Air-Filters_act_page.render_pageID_901_lang_EN_country_GB.htm looks like the cup might be un-available...
I used a washer behind a short length of 15mm copper pipe. Insert the spring, then the washer, then the pipe. The ball should fit snugly into the copper pipe. It was a couple of years ago now so you may want to check and still going ok.
Sorry I sent the above before I'd finished. What I meant to add was that I think it was 15mm pipe, it may have been smaller. Try it and see.
I run without the springs with the end plates just bent in slightly so the linkage doesn't fall out. No drama. :-[
Thanks all, megabug have sorted me out with a spring and cup so fingers crossed that's one less thing to sort out. cheers Lee ;D