Bit of flatting only few low spots and 1 high spot but looks much better today all dry pretty happy with the amount of work I did I the rear Corner Sent from my iPhone using Tapatalk
Had a week off over Xmas and worked a lot not much time off but back to it today early start was blooming cold today heater was on a lot but it's now ready to be cleaned out again Saturday and 2nd coat of primer can go on Sent from my iPhone using Tapatalk
I kept a bucket of water on the floor in my unit and had a rule - ice in the bucket, go home. It didn't happen very often.
I'm picking up a big 47kg bottle tomorrow bud be ok to paint Saturday Sent from my iPhone using Tapatalk
That must be huge! Mind your back - mine in the boat are 13Kg (of gas) and they are pretty heavy when they're full.
Another busy busy day full clean out new boy gas bottle belting the heater on amd masked out the bus again amd game it 2n full coat had my 15 year old boy as help today mixing up paint ect and had a little go did ok Tomorrow's job is engine out amd prep engine bay for paint this week and then front end same underneath and then back to flatting busy few weeks Sent from my iPhone using Tapatalk
Got a new parts washer for Xmas off the Mrs to made life a lot better cleaning the paint gun Sent from my iPhone using Tapatalk
If that's 2-pac you should have tight fitting goggles minimum and your hood up. It gets through your eyes and your skin. Stay safe.
No was kidding we was fine got extraction in there works well never had goggles on even in booths Iv been in never seen no one wear them or I'd of worn them Sent from my iPhone using Tapatalk
Its one of those things that needs care.. Even if you manage to only breathe the mist occasionally - it can cause severe permanent athsma that can be triggered by car fumes.. https://www.hse.gov.uk/mvr/bodyshop/isocyanates.htm And really the mask needs an air supply too..
Wear them masks was just had no goggles on and the internet police was onto me saluting I was going to die Sent from my iPhone using Tapatalk
