Matts 1973 Bay resto

Discussion in 'Restorations' started by Mathew Clarkson, May 19, 2015.

  1. IMG-20150415-WA0001.jpg IMG-20150415-WA0003.jpg IMG-20150415-WA0001.jpg IMG-20150415-WA0003.jpg IMG-20150415-WA0001.jpg
     

    Attached Files:

  2. Fuel filler is now in place just got to figure out the best way to tackle converting the centre panel from a left hooker one to right hand one
     
  3. Finally found the paint you were after do you still want the code ? Forgot all about it if you still need it and it's a match you can have it
     
  4. progress has been a bit slow lately hoping to have it ready for the paint shop in 2-3 weeks.
     
  5. Wow, you are scary good at this!!!
     
    Mathew Clarkson likes this.
  6. No diagrams but I did add seatbelt mounts to my panel van.

    There are two plates with captive nut mounts in the fuel tank area They sit against the floor and against the side wall in two recesses. Below the floor they have a twisted support bracket running from underneath to the chassis legs. If you search for some engine bay pics you will see them.
    Additional seat belts mounts are on the side walls below the windows and on the c-posts. I wont be at my until weekend after this and can get measurements unless someone gets them earlier.
     
    Mathew Clarkson likes this.
  7. I think I've sorted from a few pics I found and have mounted them just hope there in the correct place. What do you think?
     
  8. [​IMG]

    Any idea what the colour codes would be for this? I know it's hard from a photo
     
  9. The van is finally in the body shop after 18 months of graft and due back around the 1st week in March!
     
    art b and theBusmonkey like this.
  10. Mathew Clarkson likes this.
  11. Mathew Clarkson likes this.

Share This Page