WANTED Body cut for bodged fuel sender repair please!

has any one got a body cut to cover the 'flap' that has been cut into my bus to gain access to the fuel guage sender please. I was thinking a piece could be cut and then screwed down to make it look neat, but still able to remove for the future!

 

That's what a PO in California has done on mine, made a very nice job of panel beating the flap to fit, mastic round the edges and self tapping screws hold in place. Suggest making a template from a piece of card and cutting some thin metal sheet to shape etc etc.

 

Yeah that's what I was thinking as it should fit flusher if that makes any sense?

 

Still looking if anyone can help..

 

What size, i may have some small bits

 

I'm not sure if this photo helps? But basically looking for a cut that will overlap the hole that has been cut. A few self tappers to fix it down and it should be a tad tidier!

 

The bit i have is about 5" x 11" by the time you have trimmed it up

 

The two pics above should show rough size of cut needed, guessing 12" x 12" including a bit to fold over the front..

 

Thanks Keith but probably going to be a bit on the small size. I've uploaded a couple of pics so you can see

 

Sorry, only bit i have left, i had to do the same

 

Ok no worries mate thanks for trying

 

@davidoft
He has most things, lives in a tardis i think!

 

That's a shame I've got a piece of pickup load bed that would have been perfect size but the ribs don't match,sorry.

 

No worries mate thanks for trying

 

I've sorted this cut for you today if u r still looking?

 

Yes please that'll be ace! Let me know price and post etc
Cheers

 

Still looking for this please anyone!