Does anyone know if there is a part I can buy to block off the tinware hole on the left , I have Hurd of people bolting 2 jam jar together but I was wondering if there is a proper way
i have cut a piece of thin steel,[with snips] its extended from the hole up to the tinware screw painted it on both sides and it is held down by the tinware screw nearby
Good plan if you can weld and be bothered to strip the tins off the engine. Personally I'd just clamp something on as it won't be seen anyway.
hahaha what about two steel circles, one with a captive nut on the bottom, then bolt together. at least then you dont have jam jar lids in your engine bay and it will sit more flush.
vw make just the part circular disc from front valance of beetle. If its too big file it to the right diameter. They already have a threaded stud welded to the back and a second disc to hold it in. simples
Because (a) I had no welder, (b) I can't weld, (c) I had no steel to cut a circular piece out of and (d) there were loads of jam jar lids in the recycle bin. It did the job, better than allowing hot air into the cool zone.