uber rare, rear 3 point inertia seatbelt bracket

Yes, will pm you

 

David,

Do you have any of those brackets left, will need one for each side.

 

yup I have a pair, re you going to techenders or do you need them posting out?

 

Can't make Techenders unfortunately, so I'll need them sent out.

 

@davidoft, what's the score on supplies of the brackets. I'm so lazy/tired tonight I can't be arsed to go through the whole thread. Are there any left? I'd like a pair if possible???? B

 

Likewise, I'm too lazy to look through the thread, do you have a pair, and how much are they?
Cheers. Fletch

 

@davidoft So for the factory holes is it M10 for the top and M8 for the lower one? I can make the lower one whatever I like as I dont have it, but for the top one I bought some M8s and lets just say that they are very very flappy in the top hole.

 

@davidoft have you posted mine yet?

 

I have mine and they look like top notch kit but not had a chance to even see if I have both factory holes yet but would also be interested in the sizes of the holes.

 

Yes they are totally the dogs.

the length also would be good to know - I am guessing at this stage but they look like a 40mm for the top based on how far I could push my M8 into the whole without whacking anything, although even that seemed a tad tight. Be interested to know what eveyone else is using/used?

 

Yup, be with you today/tomorrow

 

No, the top one is a proper seat belt bolt, standard everywhere in the world, 7/16th UNF, if you buy some seatbelrts they come with some

 

What size is the lower one?

 

Which the very bottom? That's s proper seatbelt one too 7/16th UNF

 

Standard ... well you live and learn okay so I will check what rivinut is closest for the botom and order me ome seatblts.
Ta

 

Ok great - I had visions of having to find obscure bolts to fit the brackets but I have plenty of seatbelt ones. Thanks again

 

You mean the middle 3rd from the top ? That's 8mm

 

Right lets try and nail this because I am getting confused. At this point I am only interested in fitting the bracket to the van and not anything to do with the seatbelt fixing itself. So the top fixing hole(second from the top of the bracket) is a 7/16UNF and the lower fixing hole(3rd from the top) is M8 and that is how they came from the factory (on some vans) ?

I asssume the seatbelts come with bolts for the top and botom holes of the brackket , to install it?

 

Yes that's is perfectly correct

 

Great. I'll get hold of some 7/16 tomorrow. Thks.