Hi all. does anyone know where I can source a kit to put ferrules on the end of the accelerator cable? Tried Ebay, can only find cycling ones.
Yes for crimping on. Still struggling to find one. Basically, I want to make up the end of the cable into the barrel connector on my carb linkage. Just wanted to make it neat but it seems they are hard to get hold of.
i think ebay prob do them , i cant lay my hands on any as all my deep sea stuff is 80miles away at my mums place sorry .
this what you are looking for http://www.vehicle-wiring-products.eu/section.php/148/1/control-cables Or these http://www.amazon.com/Shimano-Brake-Cable-Pack-1-6mm/dp/B001EIG754 .
what I wanted to do was to put a neat end on the cable where cut. just like on the end of this cable, at the carb end ( near the red sleeve in the pic.) http://www.machine7.com/product.php?xProd=2835&xSec=814
That site is a dangerous place, I'm like a little kid in a sweet shop on there - I've spent a small fortune just lately - I just wish I had time to get it all installed
What about this, fits with an allen key grub screw https://www.vwheritage.com/shop/AC7...ttle-cable-kit-fit-all-aircooled-models-15ft/
They've been going for yonks , glad to see they have a web site at last, if you have any dosh left try here as well http://www.carbuildersolutions.com/uk
If bike ones are good enough for anchoring brake cables, they should be good enough for a throttle cable. If anything they'll be under less load than they would be on a bike. I think what you're after though is a nipple rather than a ferrule, I keep a box of the ones below at my workshop. I use them on brakes and am yet to have any issues. Cost me about 50p each... If you want to do a really neat job you could always screw and solder.
It is an alladin's cave. I avoid going on the VWP site as I'd only end up buying more stuff. Excellent for "proper" cable.