uber rare, rear 3 point inertia seatbelt bracket

Discussion in 'Late Bay Parts Classifieds' started by davidoft, Nov 25, 2012.

  1. PM'd you regarding this David.

    Matt
     
  2. It arrived yesterday, quality piece of kit David, thanks very much :)
     
  3. davidoft

    davidoft Sponsor

    :)
     
    matt likes this.
  4. davidoft

    davidoft Sponsor

  5. Hi there David - I'm a bit of a newcomer - have a '68 so I'm mostly on 'the other side'!

    Do you still have any in stock at all please? I'd like one for mine, I need a nearside rear one for a RHD. Many thanks, Richard
     
  6. davidoft

    davidoft Sponsor

    I do , so passenger side, the side without the filler neck ?
     
  7. Hi David,
    I'm the same as Dickie542 and have a '70' rhd Bay, I'm also interested in a seatbelt mounting bar for the Passenger side
    Do you have any left?
    Cheers
    Mike
     
  8. davidoft

    davidoft Sponsor

    May have 1 left will check
     
  9. David,
    If you do have one I'll have it if its up for grabs.
    Cheers
    Mike
     
    davidoft likes this.
  10. If you don't mind me posting up here, but I never got round to fitting mine, and selling the bus, so I've got a rh side one as new powder coated black in anyone's interested
     
  11. Silver

    Silver Needs points/will pay!

    I'm starting to doubt the rarity of these brackets:thinking:
     
    davidoft and PeaSoup like this.
  12. I need a couple if anyone has any?
     
  13. @PeaSoup - I'm just debating whether to put my Westy Wardrobe back in whilst also looking at adding 2 of these brackets with the full width rock and roll I have so can I ask what you did to modify the Westfalia cupboard?
     
  14. If these brackets will fit into a panel van ( I'll take one.... ) @slammedresto
     
  15. Sorry, only just seen this.

    I carefully removed the front panel, cut the sides/top back a bit, then refitted the front panel. I made it so that it is flush in line with the top cupboard.

    It looks OK and allows these brackets to fit perfectly. I can't however fully open the wardrobe door with the seat up (can open it enough to set stuff out!), fine when bed is down though - you might not have that problem though as I turned my 3/4 width seat in to a full width.
     
  16. Cheers. I have both the Berlin wardrobe and Helsinki one and the Helsinki one is already a few inches shorter so I think I should be ok if I use that one
     
  17. @davidoft Have I missed the boat on this one? Just picked up my bus up yesterday and my wife is not happy about the seat(lap) belts in the back! I would be looking for two or at a minimum the nearside - which I think is still the nearside in my lefty, although this does get kinda confusing.....it has the sliding door on that side if that helps.
    Cheers
     
    davidoft likes this.
  18. Nearside is the curb side, offside is the middle of the road side, so in a LHD the nearside is the drivers side and Sliding door is on the offside
     
    Cov1987 and davidoft like this.
  19. davidoft

    davidoft Sponsor

    Pm'd you

    David
     
  20. Hi David
    Are you still selling the inertia brackets. I have a LHD Berlin and could do with one for the off side? can you help.
    cheers
    Neil
     

Share This Page