I am finally getting round to doing the valve guides on my 1700 type 4. (W code car engine) All the suppliers list 8mm ID for the inlets, and either don't list exhaust, or they are 9mm. I'm pretty sure my heads are 8mm inlet and exhaust.. Soo... how do folks get round this? Do you just use 8mm inlet and 9mm exhaust? Does it make any difference? Or are 8mm exhausts available somewhere please?
You buy adapter guides to make them 8mm but I don't know why you'd bother.. Sent from my SM-G930F using Tapatalk
Not sure if they were a standard fitting, but I’ve seen both 8 and 9mm stems on type 1 heads. Just replace like for like.