Hi, Can anyone help ? Need at least one heat exchanger elbow for a type 4 engine.Left side as you look at the engine bay.Or both if you have. Thanks. Saon.
Might well have some - however please could you confirm which bits you mean as not sure what you mean by "elbow". Nick...
Yes I have a couple of those. Can get some pictures tonight. Can you just confirm which heat exchangers you have - the first ones in the picture (item 10 - simple 72-74/79 set up) or the second (item 11 - complex 75-78 set up) - I have a pair for both set ups! Nick...
Have found them out and taken a some of pictures. Left side one. Has a small hole as you can see in the picture but I think this would be covered by the heater control pop that slots on to that end so probably isn't an issue. Right one is very good other than the end of the bracket is missing - see next two photos for what it's like and what it should be like. I was just going to bolt a bit of right angled metal on to it but ended up getting another one in a job lot of parts and so didn't need to make this one fit in the end. Am looking for £15 each for them plus postage which I think would be £3. Please PM me if you are interested. Thanks. Nick...
Hi Nick, Thanks for putting these up it was very much appreciated.Had a call from a mate that bought a spare Type 4 engine with tin wear etc.This part happened to be included so bought locally.Thanks again. Saon.
Phew - rememebered this morning that I'd promised them to MorkC68 so lucky you don't want them! Glad you are sorted. Nick
