Tinware for Type 4 Diagram

Hi

Dont know where all of the tinware goes for my type 4 lump, and also not sure if it is all present. What is the best way to find out where it all goes, and also if i have all the bits present?

 

I got this from someone to help work out what I had and hadn't got which might help?

 

cheers bud. Now go put your phone on charge

 

Lol as I said I was sent the picture ;-)

 

http://img.photobucket.com/albums/v443/jeremyjinx/diagrams/Petrol-aircooled-tinware-CU.jpg

 

So I have been through the bits that I have and I have a few missing and a few not sure what they are for.

Unknown parts

 

No1 - goes under the head above the pushrod tubes should be 1 each side

No2- little rectangle bit should be 2 goes over the heat ex were it slots into fan house
The round bit fits to the back of the tin that goes over the gearbox (iv not got it)
Not sure on the other 2 bits

No3-is the front left bit that goes round the left corner of your fanhouse under the coil

 

Are these any help? My type 4 tinware.
More on next post.
cashwowud

 

That will help a lot. Thanks @cashwowud

 

http://www.thesamba.com/vw/forum/viewtopic.php?t=503859&postdays=0&postorder=asc&start=0

 

ignore the arrows, this is stolen pic, but very clear and easy to view, though i would post it.

 

The two bits on the right of the pic fit on top of the case centrally and hold the bottom of the airbox - or at least on my wedge they do!

Incidentally, does anyone know if the tin ware the same on t2 and t25?