Should I change the tyre

Discussion in 'General Discussion' started by matty, Sep 19, 2019.

  1. matty

    matty Supporter

    Looks a bit perished or will it be ok

    C754E316-2D14-4B2A-9255-9FF63A2B77E9.jpeg
     
    bernjb56 and Jack Tatty like this.
  2. That’ll be fine :thumbsup:
     
    crossy2112, matty and JamesLey like this.
  3. Gorilla glue will do.
     
    Jack Tatty and matty like this.
  4. Just don't put so much IN the wheelbarrow, smaller loads etc :thumbsup:
     
  5. Merlin Cat

    Merlin Cat Moderator

    Plenty of wear in that yet :). I once had a remould on s Capri unravel on the mway. The rubber was peeling off like an apple. Fortunately the noise of it hitting the inner arch caused a rapid pull over to hard shoulder (thank god for no poxy smart mways in those days) before the fabric wore through.
     
    snotty, Dubs and matty like this.
  6. Drill 2 or 3 holes through the wheel and cable tie it.:thumbsup:
     
    matty and snotty like this.
  7. Norris

    Norris Supporter

    Slap some duck tape over it. Maybe squirt a bit of araldite in it first if you've got the family in the vehicle - you can't be too careful
     
    Jack Tatty and matty like this.
  8. cunny44

    cunny44 Supporter

    Loads of tread left - just fill it with black mastic at MOT time
     
    Jack Tatty, snotty and matty like this.

Share This Page