Rear seat belt mounts??

Has anyone got some pictures of the correct factory seat belt mounting points in the back of a bay? I seem to have four threads built into the middle of the engine bulkhead but no outer ones? Well, I do but just one and that us just a home drilled into one rear wheel arch... I am sure I need two outer mounts welded in, it's just where. I will be using a full width rock n roll bed it's 3 seatbelts I have two threads already welded into the rear sides , they look factory. Can anyone help me site two outer ones? Thanks, Lee

 

They are under the window, do you have a headliner ?

 

There's plenty of pictures on this thread

http://thelatebay.com/index.php?threads/uber-rare-rear-3-point-inertia-seatbelt-bracket.18366/

 

Yes that's helpful. I need sonething to mount the inertia reel to, when I got my van it was just bolted to the rear wheel arch. Think those brackets are what I need, but I noticed the words "uber rare" so I assume they cannot be bought any more?

 

I can supply them

 

How much are they mate?

 

£90 a side including post

 

David could you just clarify for me, I have this one already in the back for the nearside . I need one for the offside. But I an not happy with the way it just had a bolt going through the rear wheel arch with a washer . Do I need to weld a mounting plate into the wheel arch or the bulkhead just above ?

 

you should have a welded captive nut on a thicker 2mm plate on the wheel arch

 

That's what I wanted to know mate, cheers. Have a few left my race car build. I just saw a sketch in a JK campers brochure, showed outside mounts on the bulkhead. It confused me!!

 

yup thems the kiddies, approx. 60mm square

 

Done. Welded the puppies in today.