I'm getting forever closer to replacing this rear chassis and I have left the bump Stop mount/torsion tube hanger attached to my cut. Will it be ok to hack off the hanger from the bus to just leave the arm from the torsion tube then reweld the hanger torsion arm through the chassis hanger? The reason I ask is the torsion tube arm seems to be cast!
I dont know whether to clean off the item below and just weld it back to my cut after removing the hanger. Anyone have an opinion?
Is it cast? Run a grinder on it, if the sparks are normal (long) then it's probably a forging and will weld fine. If the sparks are tiny probably means its cast (high carbon content) and would be a weak (brittle) weld especially welding to mild steel. I never guarantee cast welding
try running a weld on the hanger itself, you'll soon know if you can or not, if its cast it flares up and you get a really poor weld