Please help with cargo floor issue

I have been searching for the portion of cargo floor right inside the slider. Every picture of replacement floors that I have found on vendor's websites do not seem to have this section. Does anyone make it?
I am talking about the piece that is directly above the lower slider track. I would call it the top part of the sill.
Any help would be great!

 

somthing like this?
http://www.customandcommercial.com/..._lhd_only_can_be_modified_for_rhd_68-79_1121/

Not Cheap though

 

That looks like the other side to me. Maybe I am wrong, but that looks like the section that would go up against the solid panel.
Does anybody have actual pictures of these sections instead of retailer stock pictures?

 

alan schofield does it , its over £50 , u will be raging if u buy it and see all it is when it come , get some one to fold and edge on a piece of 1 mm metal and cut out the shape , might cost ye £20 or less owen nw

 

Is it rotten through? It's as thick if not thicker than the chassis and unusual to totally rot out

 

Alan schofield is the one place I haven't looked, I'm not able to access his website right now. It just wont load.

 

Can you not get a body cut ?

 

You can't get this bit. Body cut is the only way AFAIK. Very unusual to find it's not saveable...

 

or as i said make it , its easy owen nw

 

that looks liek surface rust. go at it with a flap disc before you buy anything.

 

That is ridiculous! You can get every other part for this damn bus new! /rant
I guess I will be calling my local VW wrecker.
Thanks for the help!

 

carlperkins001 it's not surface rust!

 

But from your picture there is nothing wrong with it, looks surface rusty sure but nothing I can see to be bothered with . Get a wire wheel on it

 

Thats exectly the same as the panel i have ready to go in my bus, so no that bit isn't part of the new half floor

Looking at yours mate, that will repair easily with some new steel and a floor repair panel, a lot cheaper than buying a half floor

 

The cargo floor is rotton but the top part of the slider channel looks to be just pitted with surface rust
As others have said there very thick steel and its very rare to not be able to save them

 

As i say, just take a flap disc to it and then get a pic. If you replace everybit of your bus that has that little rust on it... Youll be out of pocket.

I think youll end up replacing the cargo floor, but that bit looks like it may only need a patch or two and a clean up

 

Id clean up the cargo floor and see how bad it really is
I preffer to patch them if possible as the ones available now are much thinner than the originals

Get yourself a knotted wire brush on an angle grinder and a good hour or two stripping the floor back to bare steel will show you the extent of the damage

 

Sounds good, Thanks for the advice!

 

PROBLEM SOLVED!
Gentlemen, after some careful searching, I have found the complete assembly.
The VW NOS Part# is 211801672D
If you google the # you will see that several places carry new ones!
Check it out!

 

The part # for you right hand drive guys is: 214801672D but I can't find it anywhere for sale currently.
This page should be a big help for NOS part #s
http://vintagebus.com/parts/pdfs/5867special.pdf
I found these part #s on page 8