over riders

Fitted my front ones in the factory position:-



Rear ones need to be wide to clear the engine lid:-

 

Nice I can't decide how close to do the front on mine ??

 

gotta refit my fronts too, after theyve all been repainted, may go for the same position as that blue american bay tho, closer together

 

Probably gonna get sworn at, but I didn't like mine so was gonna chuck them!

After seeing the following they have, think I may keep them!!!
However my back drivers side one (LHD) is severely dented... anyone got a spare at all?

 

How are they usually fixed on by the way...... I haven't even looked yet! easy to get off?

 

Allen key through the hole in the rubber , probably rusted and a nightmare to get off and i think from memory 5/16 unc ?

 

Found the hole, found the right allen key..... rounded off both!!! ended up bending bottom hooks straighter and slipped it off the bumper.... lots of play due to huge dent!

know to detach the bracket and straighten the rider out!

 

where can i buy these, do they still sell them new

 

can`t buy them new ...only second hand

I usually weld a M8 nut to the bracket and then use M8 stainless dome heads to fix the overriders back on ,that way they will come of in the future

 

No worries, thanks