Will soon be able to remove the 4 gang extension lead, that sits inside feeding a small greenhouse tubular heater, and swap it over to a permanent install! Just got to fit a couple of blanks in the small consumer unit and earth the chassis, wonder where most people do this? I’m not keen on drilling lots of holes, the spare wheel recess has a nice 10mm hole that would fit a bolt and crimp perfectly, the consumer unit is under the rock and roll bed, fitted to a wooden back board and it’s a nice easy cable run. This space is storage, so easy accessible should it need tested. Any input? Cheers Tony
mains hook up complete. Fixed battery chargers complete New cabling and fuseboard and circuits complete. Also got the work hoover to clean out any debris and a bit of degreaser around the battery tray good afternoon on the bay!