i need a feed for the coil and carb choke,

Discussion in 'Mech Tech' started by art b, Oct 15, 2013.

  1. im putting my engine back in the bus,
    and ive had to tackle the tangle of wires left in there for the last 40 yrs,:theforce:

    i removed the voltage reg only disconnected wires on it
    and the rubber plug that would have went to the dynamo
    the badly wired relay for the leisure battery,,
    so now im looking to supply the coil, it must have been a switched feed from the ignition switch ,
    so where can i find one...?

    the old cable came from the leisure batt relay... but cant find what switched the relay

    what does the spade connection on the alt do...? not the large cable..
     
  2. matty

    matty Supporter

    coil and carb small black one comes out of the main loom in the right hand side of the engine bay

    the spade on the alt goes to the dash warning light
     
  3. and a feed should be piggy backed off of the small spade on the alternator to provide a supply to one side of the coil of the LB charging relay. The other side of that coil goes to ground.
     
  4. thanx..
    ive done away with the lesiure batt side for now ..it was a right spiders web of wires and joins and tape :mad:
     
  5. thanx
    im gonna have to check out whats there with a multimetre ...a great start though...:thumbsup:
     
  6. have a look for a wiring diagram for your year and model....Ratwell's site has plenty on there:thumbsup:
     
  7. all sorted i found a cable that i had marked coil....:rolleyes:
     

Share This Page