Deformation Panel

Discussion in 'Mech Tech' started by Christopher Donnelly, Oct 8, 2015.

  1. Christopher Donnelly

    Christopher Donnelly

    Hello,

    I have a query in relation to the above. I have a bit of hole that needs fixed, Given its purpose I'm guessing its thicker than the standard body panels so just need confirmation on the thickness of the sheet metal needed for this panel. Just want to have it to hand prior to cutting anything.

    Cheers

    Chris
     
    Christopher Donnelly, Oct 8, 2015
    #1
  2. wizrod

    wizrod

    I'm in a similar position.. I've this job penciled in as a winter project, so I'll be interested in the replies... ;)

    P.
     
    wizrod, Oct 8, 2015
    #2
  3. snotty

    snotty

    Can you not measure the thickness through the hole in the end?
     
    snotty, Oct 8, 2015
    #3
  4. mikedjames

    mikedjames Supporter

    ^^WHS You may find the underside of your deformation panel is actually tinsel and filler.
     
    mikedjames, Oct 8, 2015
    #4
    Dicky likes this.
  5. davidoft

    davidoft Sponsor

    2.5mm
     
    davidoft, Oct 8, 2015
    #5
  6. Christopher Donnelly

    Christopher Donnelly

    Perfect thanks for the replies, I suppose if I had lay under the van a couple of minutes longer I could have figured it out.
    tuesday_wildchildME
     
    Christopher Donnelly, Oct 9, 2015
    #6

Share This Page