Now the engine is out, reason being the clutch was not working. Just doing a bit of checking, should the mechanism return under spring pressure when moving the clutch operating lever? Also, all the clutch arm refurbs seem to fit up to 1975, mines a 79, I assume these kits will do for mine but any advice would be good. Cheers
Zed, Not looked in detail yet, its just that the arm doesnt return when you operate it by hand, donte tell me I could have replaced it without dropping the engine lol, all the springs and refurb kits seem to say that they fit to 75 buses only, is it fair to assume that the spring will fit mine? I need to have a good butchers this weekend, have been concentrating on the engine in the garage thus far...
I thought they were all the same but apparently not. Looks the same though... http://www.vwheritage.com/vw_spares_Clutch-shaft-kit-urethane-20mm-T1-mid-72-T2-76-Bugpack- TBH I'd risk one of these as they're so cheap, or ring Heritage and ask what the score is. AC198502911_act_shop.product_pID_104695_lang_EN_country_GB.htm?crumbStartPage=3&crumbStartRow=41