I've been fitting a new loom I've made to someone's bus when I took the old the old loom out, I didn't notice I pulled off a couple of wires to the alarm so now I don't know where they go New loom is in and I've reverted everything back to factory and it all works....but I want to get the alarm re-instated does any one have an installation manual? ....I know it might not help as all the wires are black but I might be able to narrow it down a bit trouble is, even if I connected it up as it was, it was never installed correctly IMO as the owner had to install a hard start push button to bypass the key switch as the key switch never worked (key switch is fine now I've wired it as per original)
just a quick flick through the net turned up this if its any good 1 - Blue - Interior light pin switches (neg) 2 - Blue/Red - Boot switch (neg) 3 - Green/Black - Low current programable output 4 - Green/Red - As above 5 - Black - Earth 6 - Black - Earth 7 - Orange - Ignition sense 8 - Red - 3a 12v 9 - Pink - Central locking (Configurable) 10 - Blue/White - As Above 11 - Black - Immobiliser circuit 1 12 - Black - Immobiliser circuit 1 13 - Black - Immobiliser circuit 2 14 - Black - Immobiliser circuit 2 15 - Red/Yellow - Indicator supply (15a) 16 - Yellow - Indicator output 17 - Yellow - Indicator output 18 - Green/Orange - Accessory output (neg during trigger) 19 - Green/White - Central locking (Configurable) 20 - Pink/Black - Central locking (Configurable)
thanks, yes it is helpful. I did spot that on line, but I was hoping to see how the wires were bunched. I'm pretty sure the ones up by the ignition switch are the immobiliser circuits but wanted to work out how I should connect them. Worst case scenario I could buzz them out with the multimeter and see if they make/break when the alarm is activated I suppose
