Spare engine rebuild

Discussion in 'Mech Tech' started by the 3 crispies, Jul 11, 2019.

  1. Accumulated few parts for building engine found these parts do they look serviceable. [​IMG][​IMG][​IMG]

    Sent from my SM-J510FN using Tapatalk
    Datsolow likes this.
  2. All look good,heads will need stripping and refurbing,B&P,will need new rings and honing.
    mikedjames and F_Pantos like this.
  3. Was concerned with piston heads

    Sent from my SM-J510FN using Tapatalk
  4. You’d have to measure Barrels and check for wear
    F_Pantos likes this.
  5. Hone and do ring gap check.
    F_Pantos likes this.
  6. That’s no good if they are worn past the wear limit ! If you can feel a lip at the top they are toast
    You will need to check guides in heads for wear and I’d put new valves in
    the 3 crispies likes this.

Share This Page