Hi all, so the cable inside the sliding door has snapped, I cannot find a replacement on any of the suppliers, can anyone advise me or provide a link etc? cheers
Easiest: you will need to buy a replacement set of locks complete with cable. Harder: engineering creativity. . depends on where the cable has broken. If its in the middle, you can cut back the outer to expose the broken section, put a metal spacer bar between the ends of the outer and splice in a section of steel wire using a couple of rigging wire clamps. If its broken at one end, weld a rod to the moving part it is attached to and clamp the wire to it, with a spacer for the outer. Look at bike cables and consider modifying them. Personally its a challenge I know I would beat..
cheers buddy, it snapped right as it goes in the lug so no chance of a connector, if i can't source a new one it looks like making a long enough cable fit. cheers
Bicycle shoppe , buy a suitable cable and make your own ? I've never had to do it but shouldn't be too challenging... Sent from my SM-G960F using Tapatalk