Sink recommendations?

Discussion in 'Restorations' started by Dicky, Aug 25, 2014.

  1. Got one of these in our boat, pretty good I think. No idea on the tap, just something off ebay a while back
     
  2. I should check when buying which way the water goes down the plug hole, I recommend clockwise, you get a better swirl.;)
     
  3. Cant remember tbh. From memory it was too deep i think. Will check, was it on a message?
    Is tap fitted to sink or worktop?
     
  4. Into the worktop, I sealed the edges of the hole with varnish before fitting the tap
     
  5. cant find the measurements. mind you i couldnt find this thread either when I came back to it. Thought id posted in general. Did i get moved?
     
  6. Yep looks like its been moved to mech tech, will dig out measurements again and will bring it to techenders so you can have a look if you want
     
  7. Found the original post and it was too deep ie width was gread - depth of bowl wasnt an issue but the front to back measurement was 470mm which is bigger that the unit depth and i want it as slim as my fridge will allow (aiming for about 420). Thanks anyway. Might change plans at some point though. More or less built one unit and didnt like it so who knows!
     
  8. Zed

    Zed Gradually getting grumpier

    I have a few crappy old sinks that would meld well with your bits and pieces interior. :D
     

Share This Page