seat and mot law

i cannot find the mot post so can anyone advise on following please ? thing is , the drivers seat in my bus is bolted to the floor , no runners , cannot move ,>>> is that an mot fail ? and if it is, if i source any old seat and runners from breakers yard and fit same in working order , will that be agreeable re mot law ? ta for opinions/advice

 

Mine is welded in and I've sailed through the MOT's I've had done since owning Rusty.

 

If I remember right - it doesn't have to have runners. If it does have then they have to work. So you should be OK.
Correct me if I'm wrong somebody

 

Mine have runners etc but the seats are welded in all the same. Guess it comes down to the tester.

 

as bern says, if it is adjustable it has to adjust, therefore being permanently fixed makes it unadjustable therefore it's a pass.

 

ta 4 all that advice, will leave it as it is (and argue the point on mot day, no doubt )

 

Yup mine are fixed in after the front arches were tubbed, got an MOT last year (in again on Tuesday) so no probs.

 

Mine are bolted in, MOT'd it this month, no problem.