Saggy Bottom.

Discussion in 'Mech Tech' started by Pony, Feb 23, 2014.

  1. Not mine,but the van's. Is there any measurement to tell. Stock type 4 set up. Front end is looking a little high, but all appears even at the rear.
    It may be fine but I've an inkling.
    Ta muchly peeps.
     
  2. The front always looks high with no driver in the cab. Saggy bums (if they do exist) fixable by a bit of spring plate twiddling, if it bothers you.
     
    Pony likes this.
  3. Oi I've been losing weight:)
     

  4. In an attempt to squeeze through new found passages?

    On that topic my eldest daughter has paid interest in going underground at some point and i wouldent mind another dose of positive ions
    Thats if its at all possible with the amount of water we have had the past few months
     
  5. Had a shuffty down Goyden a couple of weeks ago, had to traverse the side of the entrance passage to get in as there were about 3 to 4 Cumecs (cubic meters per second) of water going in the usually dry passage. Had a wander to The Bridge, a few tons of wall and roof have dropped off here and there. Tip top waterfall coming into the Main Chamber though, absolutely awesome, like being stuck in the bath with a jet engine.
    Give me a bit of time bud as the light you used has dropped a cell and is positively shot.:( Be happy to tha lass. Will make a few calls and see if I can scrounge some spare gear. How tall is she?
     
    paradox likes this.

Share This Page