Don't hold me to it but it looks like the rubber stop on the slide door hinge mech , just remember his door fell off and seen a rubber bit , worth A shot may be wrong !!
Looking good with the new paint , no idea about the rubber stop will look tomorrow at door on mine Lpg @55p now
Cab doors almost complete. Think I'm going to get new scrapers. fiesta Ghia sunroof back in too. Bus is almost weatherproof now just 6 windows to go in.
Just a quickie. Here's the dash pod I made over a year ago. Flattened and first coat of low sheen black.
Cover is off. Had so much rain it was trapping water and I thought it might as well just run off rather than be sandwiched between the cover and the van.
Got throttle issues. Here's a video. When I flick the throttle it doesn't settle back to idle right away as it should, it lingers and slowly drops back to idle. Couple of times it hasn't settled back too. Not sure what to do. I have set the idle speed to a level just above cuts out point.
http://vid1291.photobucket.com/albums/b550/dirtyboycle/20150201_132739_zpsw9xpjpbj.mp4 sorry for the external link but it wont upload to here
yeah, it is a little, i set it there so that it stopped cutting out enough for me to video it. Somethings not right. I don't want to have to pull the carb apart if i can avoid it because thats a can of worms, and the haynes is confusing me. Been looking at the club8090 wiki and theres loads of info but nothing that is the same as the problem i have. Basically, i took it for its first drive today, just round the block, and it was cutting out when i had the clutch down to change gear, the clutch was down for about 5 seconds as i am also having trouble selecting gears, which is another question for later.
A slight leak on the inlet side will cause it to stuggle or cut out at idle Spray some wd40 around the gaskets and if the rpm rises you have found your leak
cool i will have a go and report back in a bit. Thanks for the support guys, i need this 25 done and gone so i can build my BAYYYYYYYYY but i want it finished and working properly before i sell.
was going to start it up but the battery is flat again. Can a battery really die within a year and a bit??? or have i got something draining the battery somewhere!!!