Anyone got a single head bolt for a 1600 and would be happy to go to post it at this point in time? It will save me buying a full set
Ooh. Don’t know - will check the one that fell out tomorrow , I thought they’d be the same for some reason , but guess they changed throughout the years didn’t they
On your engine you will have some longer studs and some shorter ones. If I remember correctly its the top two middle studs that are shorter on each side.
How did it "fall out". This may relate to whether it needs a little more than just screwing in a new one.
I had a ‘blowing’ noise last year , thought it was the exhaust , it wasn’t - someone did to check valve adjustment and I found that the lower bolt ( nearest to the rear) had sheared off at the casing and just pulled out though the head . God knows how it sheared , not my doing anyway , either over tightened on assembly or the engine was dropped by the last people to remove it when the fuel tank was replaced shortly after I bought the camper ( I strongly suspect this to be the case) hopefully this is the reason for the blowing noise
Let me know if he hasn’t because I have. You may end up needing to drill out and put a case saver in , if the case isn’t cracked around it!
Here you go Mike , the offending article , it was definitely blowing around that stud as well Sent from my iPhone using Tapatalk