I need a picture of how 1600 engine bar mounts to chassis...

Discussion in 'Mech Tech' started by Joker, Aug 13, 2011.

  1. anyone please? I need a pic of the mounts to the chassis and how the engine bar fits on the rubber mounts. Its a long time since i've worked on an uptight. Does the bar go over the top of the rubber mounts? if so what are the 2 holes in the rubber mounts for?
    ;D
     
  2. Bar under the mounts, two holes for M8 bolts.
     
  3. you should be able to make it out here :D


    [​IMG]
    [​IMG]
     
  4. thanks both
    ;D
     
  5. one more - are the bolts which go into the engine M8 or M10? any idea of length?


    ;D
     
  6. the top two are 38mm and the bottom one is 67mm, i have just been out and measured them as they are currently off the engine. the bottom two are thicker than than the top one, but not sure on the the actual size as i dont quite know what m10 and m8 actually means, sorry ???
     
  7. cheers
    :D
     
  8. Think top are M10 and lower is M8
     

Share This Page