Has anyone got this bed?

Has anyone got the same bed in there bus as me
I need to know if its supposed to sit on top of a ply floor or sit on the cargo floor?

 

on ply i think

 

wont you know if it lines up with the bulkhead in the bed position ?

 

It maybe an older blubird, i think it can sit on the ply floor (it would only tilt the front of the seat up a tad anyway), the holes where its bolted to the arches may be slotted too so may push back a little bit and at same time move up.

 

its like my sisters and they had to raise it to get it to line up, dont know how much thou trial and error

 

Its not fastend in yet so i cant get it to move into the bed position without it all folding up on me

I dont want to drill any holes in to fasten it in as if it does need the ply below it the holes in the bodywork could end up in the wrong place

Im not at the interior build stage yet its just been puzzling my mind for a while

 

Mine looks like that and its fixed 12mm from the crown of the corrugation in the cargo floor and its perfectly level.

 

So its looking like laying ply down then fitting the bed
Good i was hoping it was that way