Got a brazillian deformation panel?

Has anyone got a brazillian deformation panel? I'm putting a brazillian front bumper on my normal defo panel.. So need to know where the fixing holes are.

Can someone get me some measurements for the fixing holes. Or a template?

Will pay mucho cash

Cheers in advance, Carl

 

sorry carl ,i havnt had a brazillian in ages bud

 

Another double entendre thread!

 

Yeah....if you measure up from your front bumper about three inches and trim both sides evenly, you should be right....never seen a template though....I usually use a mirror....

 

me n carl are good buddys he knows id help if i could bump

 

Buy the bumper - they come with a free template!

 

Haha, yeah I got the front bumper. I've offered it up and got some pretty rough positions for the holes. But would prefer something more "exact" if possible.

Was hoping someone could do one of them 'crayon over leaf' rubbings like in middle school, but of a bumper .

 

I thought 2 of the holes were in the same place

 

Drill your bumper to match your deformation panel ?!

 

I've just bought one. It's at the van at the moment but I can do you a brass rubbing of the holes Friday evening if you'd like.

 

Nope

 

Nah the bumper has a curve, someone else done it and it's more difficult..

 

If you would I would be very appreciative! Top bloke!

 

Ok, will do. I looked at the deformation panel this evening when I took it to my welder. There are two vertical bolt holes and then two other holes horizontal and inboard of the vertical holes. These looked like the square bumper mounting holes but they don't line up with the holes in the actual bumper.
Can you PM me your address.