Took the fuel pump off this evening just to check a few things plus i have got another comeing tomorrow complete with a new push rod , I noticed that on the pedestal in the recessed bits of the pedestal there was a liquid which smelt very much like petrol , should there be any form of liquid fuel or oil in the recessed bits of the pedestal ? If no might be why my engine when it is running is getting very hot and the oil did smell a little bit like it had fuel in it although when i had a sniff the engine had been running so was hot . Also just want to check that the rod hasnt been put in upside down , does the curved "pointy " end go into the case , and the flat end goes against the pump ? thanks
changing the oil as there is fuel in it , do you recon i need to run it for a short while , dump it , then fresh oil and run for a bit , then dump that and refill with fresh again ? or will just dumping the old oil and a refill with fresh be ok ?
I'd just dump and fill TBH. Let it drain and leave the filler cap off for an hour or two before refilling?