Good morning all.. I plan on going the tdi route in my bay and my current engine support crossmember is a bit rubbish. Will i still require the original crossmember for the tdi installation or would a custom support be more fitting.. Many thanks in advance for the support Sent from my SM-G935F using Tapatalk
Ok. I will remove the crossmember then prior to installing the tdi motor.. Many thanks Sent from my SM-G935F using Tapatalk
One thing i wish to ask...the area where i assume the engine trim would sit...whats the best way to approach repairing these... remove entirely..? Are there replacement pieces avail? Looks like mine have been fibreglassed at some point Both sides rear corners have these "plates" is this oem? Or been added for a reason? Sent from my SM-G935F using Tapatalk
That looks like the lower part of each body panel has been replaced . Normal rusty bus treatment. Hopefully the chassis box sections are still strong enough to have different engine supports fixed to them.