Having cleaned the deck of the heads , the last fin is very close to the head.. 0.3mm. Would it be better to take off last fin and let a proper amount of air get along the head face? Sent from my SM-G930F using Tapatalk
It's at the head end..so won't get much air down the face of the head, lots of other holes in head I suppose!.. I'll put the angle grinder down then.... Sent from my SM-G930F using Tapatalk
Took some face off the head and cylinder fin with a finger sander as couldn't be bothered with the machine shop Daylight gap now... took a little more off after that photo too as head "fin" looks quite thick and can take a bit of loss... Sent from my SM-T580 using Tapatalk