cuts

Is there a good engine bay door?

 

Is that a philosophical question?

 

could be - as in " can an engine bay door be evil" or " do engine bay doors know the difference between right and wrong"

 

The only good Injin (door)...is a dead Injun (door)
Philip Henry Sheridan 1869

 

l

 

dicky do you see the little lever

 

I've got a square knob near the handle and it's the lock for that I need. I'll get a picture

 

Not that one, that looks later I think.

 

Hi
what price on the floor section 4th pic down & what condition is it in, Could I have dibs pending cost & a discussion with Restoman? Based Preston Lancashire

 

Nope sorry

 

That is the hatch cut is that what you are after?

 

If you have rear corner cuts I need rear chassis legs, bottoms of the D pillars and the nearside rear corner panel...

 

No need a floor section full width of van from 12" before rear seat back, the angled seat back riser section & about 4" flat top floor section, if that makes sense?

 

Top section and down to the first join is good then bottom needs replaced cant remember about the floor, in the morning will take pics and show you, but i doubt if i would knacker up the (above engine bay) piece of flooring as that is excellent, unless you make it a good offer lol
Then anything is possible

 

is it possible to see pic of floor beneath where R&R bed would sit & slanted riser between inner rear wheel arches which is actually all I need

 

was not worth the effort to click button for pic sorry
Its goosed, good part is above the engine that is very good and down to first join between arches

 

Dont some of the dealers do a bit that you need, i am sure someone said that they could get floor and up to first join between arches

 

Ok thanks for looking. Which dealers? I haven't looked tbh

 

I've got a 72 late with an inspection hatch