WANTED Cab door vent (and runners)

Hi,

Rebuilding my cab doors at the moment, and I'm missing a cab door vent and runners, so need exactly what's shown in picture below.
I'm missing the Right hand side one, although I think either one would fit?

Many Thanks
Will

 

i may have a vent floating about....will have a look tomorrow and let you know....you can have it

 

Thanks @vanorak

 

not had a look yet....sorry....remind me if I've not replied in a day or two

 

Hi @vanorak , managed to source some runners, but I'm still in need of the vent if you have it.

Thanks!
Will

 

Jeez...Sorry Will...I've completely forgotten about it...which bit did you need again?

 

Ok...the blue bit....

 

yep blue bit please!

 

@WillK If you're still after these I believe I have a pair in the garage (hopefully have the metal spring bit too).

 

Big thanks to @vanorak for sorting me out with a vent, hope to repay the favour sometime!

 

I'm going to putting new door panels in. I have both blue bits and one black bit (that does in the door panel which is from a donor panel).

Do I need those black runners from the first picture and where do they go?

 

Black runner bits are riveted on to hold the blue sliders in place.
There's 2 runners per side, the bottom one is *usually* welded to the door, so should be there. The top one is riveted on, and is removed to allow the blue bits to be taken off.

Check your doors, but I'd guess you're going to need one runner per side.

Will

 

Thanks for that i'll have a look.