Bonds primer + zinc

Discussion in 'Mech Tech' started by Valveandy, Jul 11, 2019.

  1. Hi all,
    Would this stuff survive on the outer casing of heat exchangers?
    Cheers all
    A
     
  2. Is that Bonda Primer? Excellent stuff but hard to get hold of and I’m told they’ve been taken over by some other unknown brand and could be lost forever.

    I used it on my HEx and a top coat of grey paint, all pretty thin. It’s survived the 20 minute cam burn stage ok, not quite sure about full operating temperatures yet but don’t think there will be a problem.

    Didn’t use it on the headers though, used VHT paint for that.
     
    Valveandy likes this.
  3. Thanks for the info, I'll give it a go. I just realized we're quite close I'm just on the north side of the rugby stadium
     
    mcswiggs likes this.
  4. I usually do my heat exchangers in grey stonechip.
    The outsides never get hot enough to cure VHT which washes off in the end.

    For steel headers, VHT or simply rust.
     
    Valveandy likes this.
  5. Ha- I’m just on the south side! Not at the moment though, I’m with the van in
    the south of France...
    76F2C414-9106-419F-80E7-AD442FB97AA5.jpeg
    I’ll look out for you when I’m back!
     
    Valveandy and F_Pantos like this.
  6. we might just have to pop in Sussex arms:beer:
     
  7. Now that is the best way to kick tyres, and one of my fav pubs too...
     
  8. We'll make a date when you get back.
    Presently in the prince Albert with my daughter:)
     
    mcswiggs likes this.

Share This Page