Hi all I disconnected the accelerator linkage connection during the cab refurb and failed to take some pics of the before. Just want to check this is going in correctly. Under the bus: Inside the cab: I bolted the bar back onto the link that comes through the floor but it slipped immediately, what am I doing wrong? many thanks Tony
Figured it out, the end of the bar fits into the link, seems to be holding now. Do shout if anything looks wrong on how it’s connected. T
Why is the endstop adjuster screw lying against the floor panel, rather than its tip pointing up. ? The wear slot in the hole that the cable is hooked through is pointing down rather than in line with the cable pull . I think you have flipped it over .
