Has anyone got a brazillian deformation panel? I'm putting a brazillian front bumper on my normal defo panel.. So need to know where the fixing holes are. Can someone get me some measurements for the fixing holes. Or a template? Will pay mucho cash Cheers in advance, Carl
Yeah....if you measure up from your front bumper about three inches and trim both sides evenly, you should be right....never seen a template though....I usually use a mirror....
Haha, yeah I got the front bumper. I've offered it up and got some pretty rough positions for the holes. But would prefer something more "exact" if possible. Was hoping someone could do one of them 'crayon over leaf' rubbings like in middle school, but of a bumper .
I've just bought one. It's at the van at the moment but I can do you a brass rubbing of the holes Friday evening if you'd like.
Ok, will do. I looked at the deformation panel this evening when I took it to my welder. There are two vertical bolt holes and then two other holes horizontal and inboard of the vertical holes. These looked like the square bumper mounting holes but they don't line up with the holes in the actual bumper. Can you PM me your address.