Would these do the job https://www.amazon.co.uk/sourcingma...ocphy=1007151&hvtargid=pla-585854790376&psc=1
Any bung or grommet will do but water will creep under the edge, the snap-in plugs seal against the face and the centre of the hole and are better IMO.
Now look what you've made me spend more money on... and then you mention they do an epoxy mastic too!... Sent from my SM-T580 using Tapatalk
That suction cavity wax gun will do fine for the underbody wax but to get the most out of the cavity wax you will be better of using a pressure pot gun. When I tried both inside lengths of cardboard tube the pressure pot gun gave a lot better coverage than a suction gun. I think I paid about £70-£80 for mine So there not cheap but worth it in my opinion.
The silver tin at the bottom left is a pressure pot...... just hope it's up to the job.. looks a bit light Sent from my SM-G930F using Tapatalk
Snap! Just cavity waxed and undersealed ours! Got a good bit matted into my hair. Sent from my iPhone using Tapatalk
Are you sure it’s a pressure pot? It doesent look like it could handle much pressure. It looks to be the same as standard screw on cavity wax cans
It recommends running at 75psi so takes a bit... but it looks a bit light to me too..it is just a refillable wax oil type container to use the 5lr tubs... .... if I post an amusing me covered in wax photo in a couple of weeks I'll give them a bad review Sent from my SM-G930F using Tapatalk
Have a look at the cap part of the gun that the can screws onto If there’s a vent hole in the cap then it’s a suction gun.