1/2"/13mm ID barbed fitting, preferably metric thread. Can anyone point me at one? I'm tired of the Internet. Ta.
Pretty much any you like! I seem to have loads of them, mainly in brass but also stainless, not sure why I have loads but I do. Mainly 1/4 npt but I have Taps to go with them (for borrowing).
Would that I had TIGing kit. Looking at the manifold today to try to find a meaty bit. Thought "If I had some TIG kit, I could just build that up with some ally weld". Alas, I don't
Right, Mr @Top Banana Racing to the rescue. I now have a nice 10mm barb for servo-ing . Just got to Dremel the inside end of it flush tomorrow. Much appreciated!
On this subject, what diameter is the main vacuum pipe - front to back? Reading this it seems 10mm is acceptable if that's what the manifold take off is, yet the connection to the servo is 13mm, can anyone clarify this??