Piece that connects your long heater tube to the rear exchangers. Is there on available? Mines missing.
I don’t think so, but someone will correct me on that I’m sure Going back a few years there was a guy making the y peice out of grp as a two part kit. Apparently it’s not possible to install in one piece as the original is in stalled as the floor is being built. I think @paradox had a good look at the grp versions.
Schofields sell one. It’s expensive and not very well made to be honest. It’ll fill a hole. I had to seam seal the life out of mine to make it airtight. Sent from my iPhone using Tapatalk
I went down the same rabbit hole as @JamesLey by trying to fit one with the floor in. First you need to split it back into three parts, remove engine and gearbox and then swear a lot because it’s still an impossibly tight fit!
