While stripping down my CU engine I had no 3 cylinder stuck to the head. In removing it the liner has cracked and bits of cooling fin come off. Does anyone have either a spare cylinder, or a liner/piston set, they could sell me? I am reluctant to buy a full set, all the pistons and other liners are fine and working well. They are stock pistons, measuring 93.98mm. Thanks
If you decide to change just one cylinder make sure it is the same length as the others: you may have to trim one, or three.
Good point, but I am hoping any height differences will be small and within the scope of cylinder shims.
You could do it that way but the selection of cylinder shim thicknesses is rather limited – you could always make your own if necessary.