Some of you probably remember my bus from before but here is a breif overview this how it started out 12 months ago and then with a little chopping it went to this
and now front end is back together with door gaps lookin very nice passengers inner, centre and outer sills have all been replaced along with pass rear arch, rear corner and battery tray oh and a new inner rear panel aswell along with a shed load of other little bits here and there i am currently trying to save the original chasis number stamped plate in engine bay. my basic list of weling left to do is -drivers rear arch -inner and centre sills on drivers side -a few top hat repairs -all the jacking points and outriggers -sliding door repairs (around window seal area) -and to weld loads of old screw holes up inside then get some filler on the go and start prepping it all. i will try to get some more pics up soon when i can find them all : thanks for looking, steve.
Hello all, just a quick update..... found quite a large hole in the rear chasis rail in engine bay, so i have made a section of chasis leg but still got some more to do that about all for now, thanks for looking. Steve.
hello all, just a couple of update pics of me chasis leg progress.....spent most of saturday on this and om pretty chuffed how its come out i just gotta make a peice to fit top of leg and then start reconstructing my engine bay Thanks for looking, Steve.
top job on the front 8) and the dreaded chassis repairs it sends shivers down my spine keep up the good work