Hi Thanks to everones advise today I took out engine and removed firewall Changed all breathers, Changed fuel fill line and elbow for filler cap Fuel line and filter Pump line to carb all in bio proof hose Connect breather system to K&N Changed spark plugs, leads, distributer, rotor arm. and yes forgot the throttle cable so had to pull it twice Running as sweet as a nut now BUT When I came to reconnect heater cables, I'm not happy I got the barrel clamps connections right. Does anyone have a pic as they seem too loose
No pic but when my cables are adjusted correct my sit relaxed. My first one so maybe wrong but fully close and open so I'm happy Sent from my SM-J320FN using Tapatalk
The way I do it is to set the flap lever to closed or up then pull the barrels in the loops on the end of the levers forward along the control wire ends to start closing the flap. Then I finger tighten the screw in the barrel so the flap spring pulls on the wire when you let go of it. Then loosen the screw and let the flap slide back to open then do up the screw properly. Like this they are just slack with the lever up on the dash.