Another new toy.

Discussion in 'Photography' started by Rustydiver, May 20, 2015.

  1. Not been on here much lately too many toys to play with
    My new 3d printer.
    oxiderenegade, tommygoldy and Poptop2 like this.
  2. Poptop2

    Poptop2 Moderator

    Oh yes, Awaits the first post requesting be plastic hard to get parts
    Rustydiver likes this.
  3. :eek:
    Poptop2 and Rustydiver like this.
  4. Was thinking about this the other day - surely those with original Devon handles would be champing at the bit to get them remade!
    Pudelwagen likes this.
  5. If anyone can draw them up on a cad, I can have a go to see if it works.
    File formats .stl, .obj, .dae and .amg. .stl seems to be the industry standard.
    Havnt been successful in printing out in ABS yet just got to get the heat bed right.
    It will have to be in ABS it will take on higher temps in the van PLA will start to melt and go sticky.
    I am limited to 15cm x 15cm x 10cm.
    Last edited: May 21, 2015
  6. A biodiesel forum im on now seems to be more about 3d printers, only a few guys but nice and helpful, if its of any interest
  7. Thanks.
    That's some serious work they have done there.
    I'm on a mulirotor forum ( for flying and crashing helicopter things) they are good on there.
  8. I believe @zed was a CAD man. You two could set up a business!
  9. Zed


    I dipped out just as solid modelling got easy and can't make any of those file formats AFAIK.
  10. Put me down for a couple of Moonraker cupboard door handles!

Share This Page