just opened my nice new svda dizzy from accuspark ....looks great ....went to fit it and it wont fit ?put the 050 bosch one back ...then tried again to fit the accuspark model .....no luck .....i had to fit the leccy bits back into my old dizzy instead and bang that back in ....ive not phoned them yet as im quite busy ...anyone else had same problem.....i did measure both dizzys and the accuspark one is a fraction bigger when measured with micrometer thing ..esp around the base ....so i sanded and filed but no luck ....p.s. it does look a bit cheap compared to a bosch unit .....also they state that there dizzy caps and rotorarms are bosch ...this isnt the case .....they are copies....and the rotor arm i received within the unit was broke ....gona phone em today at somestage ....just a heads up for thelatebayers.....the leccy bits fitted well and worked str8 up ....so that bit is good .....
PS Just noticed that their vac dissy with points retails for...£30. You get what you pay for, I think.
The only thing I found with mine was it was tight going past the o ring but a smear of oil and it went in a treat